• LOGIN
  • No products in the cart.

E – 1648 Limiting Arc Flash Exposure

Intended Audience: Electrical and general engineers

PDH UNITS: 3

0 STUDENTS ENROLLED

    Arc flash incidents may happen despite care taken to avert them. In such circumstances, it is always better if the incident energy is low and staff is ready for the worst by implementing adequate PPE. Arc flash incidents can be cut down by use of adequate equipment, proper preventive care, planning and coordination of operation, as well as skill improvement and real experience. Also crucial is the mental and physical circumstances of the staff such that the dropping of equipment and tools, accidental touching, etc., are averted.

    This course is suitable for engineers with a desire to understand the how to limit arc flash exposure. Course covers discussion on preventive operation, limiting fault currents and adjustments of protection settings and personal protective equipment.

    Learning Objectives

    This continuing education course is intended to provide you with the following specific knowledge and skills:

    • Limiting arc flash exposure
    • System preventive operation
    • Limiting short circuit currents and arcing times
    • Adjustment of protective settings
    • Personal protective equipment selection

    Course Reviews

    N.A

    ratings
    • 5 stars0
    • 4 stars0
    • 3 stars0
    • 2 stars0
    • 1 stars0

    No Reviews found for this course.

    TAKE THIS COURSE

    Once completed, your order and certificate of completion will be available in your profile when you’re logged in to the site.

    Copyright 2019 · All Rights Reserved PDH Source, LLC 513 E- Main Street # 981 Charlottesville, VA 22902 USA